Protect Your Winter Toys in Self Storage

Protect Your Winter Toys in Self Storage

Winter has been over for a few months. Don’t put off storing those winter toys so that they’re in top shape when you head to the slopes again next year. We have you covered. Whether you’re storing skis, snowboards, or snowmobiles, Trusted Self Storage has a wide variety of sizes and types of secure self storage units to protect your winter toys in self storage and ensure they remain in the best condition.

To avoid potential damage to your expensive equipment, there are factors you need to consider before placing your items in storage. We’ve compiled a few suggestions to help you prepare your winter gear for storage.

Protecting Skis and Snowboards

Remove the Dirt: Spray them down with a garden hose, trying not to force water into the bindings. Avoid degreasers or detergent as they can affect the binding lubricant. If there is a build-up of grease or pollen on the bases, use a soft cloth dipped in a little citrus solvent.

Check the Edges: Sharpen the edges of your skis and snowboards to remove the most obvious burrs and reduce the chance of rust. Warmer weather is a good time to have a base grind done to repair any edge damage incurred during the winter.

Wax the Bases: Hot wax the bases with an all temperature or softer warm-weather wax to protect them from oxidation. The wax should cover the edges to reduce the chances of rust.

Loosen the Binding Springs or Remove the Bindings: Skiers should loosen the DIN settings on both toe pieces and move the heel pieces into the ski position. This decreases tension in the springs to keep them in better condition. Snowboarders can remove their bindings or loosen the screws to reduce stress on inserts and prevent dimpling of the base.

Protect Them in Self Storage: A climate-controlled self storage unit with no sunlight is ideal for both skis and snowboards. To ensure that skis don’t fall over, strap them together at their natural meeting point and pad them.

Don’t Forget Your Boots: Pull the liners out of your boots and make sure everything is completely dry. Your next step is to buckle the boots loosely so that they hold their shape. Check heels and toes for wear and replace if necessary. If your snowboard boot laces are worn, replace them now so that they’re ready for the next season.

Snowboarding and skiing gear.


Protecting Snowmobiles

Clean and Wax the Exterior: Clean the exterior with warm, soapy water and a sponge; be sure not to forget to clean under the hood. Use a high-pressure washer to clean the track, runners and suspension. Once you’ve finished cleaning your vehicle, apply a coat of wax to protect it and make it easier to clean in the future.

Maintain the Fuel System: Before you decide whether to store your vehicle with a full tank of gas or not, be sure you know which type of fuel system you’re dealing with. For older models that use a carburetor system, drain the tank. For fuel-injected systems, store your snowmobile with a full tank of gas to reduce the risk of condensation getting into the fuel system. Add a fuel stabilizer to prevent corrosion.

Drain the Carburetor: To keep the fuel from evaporating and creating a damaging chalky residue, remove the carburetor float bowls and drain excess fuel.

Grease Lube Points and Chassis: Add grease to any point with a grease fitting. Use WD-40 or a similar lightweight oil for suspension rails, exhaust, and nuts, and avoid getting it on the clutch or belts.

Remove the Battery and Belt: As long as you’re storing your snowmobile in a climate-controlled storage unit, you can remove your battery and keep it in the unit away from direct light. You can either use a battery tender or trickle charge the battery. Remove the drive belt so that condensation won’t build between the belt and the clutch. Store the belt unrolled.

Raise It and Cover It: Ideally, you should store your snowmobile on a set of snowmobile dollies to keep it above the floor. To prevent rodents and other pests from making your vehicle a summer home, scatter dryer sheets around and stuff the muffler outlet, carburetor intake, cooling system intake, and outlet holes with steel wool. Finally, use a soft, lightweight, well fitted cover to prevent scratches or moisture build-up.


Now that you’ve read these guidelines, you have no more excuses. Get those winter toys prepared for storage in a safe, climate-controlled facility before summer rolls around. When you’re ready to use them again, they’ll be waiting for you in the same perfect condition as they were when you stored them.

Back to Top